TLZone Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,530 Posts
Discussion Starter #1
I have a set of standard bore cylinders that I had shortened for my track bike engine. They were shortened by millenium 0.4mm to decrease deck height and raise compression. One of the cylinders had to be replated by millenium, the other cylinder still has the Suzuki plating in good condition. Also included will be a set of 0.007" base gasket spacers to adjust squish. With standard base gaskets and the spacers my deck height was 1.00mm and 1.05mm. They are packed away in storage right now so I can't get pictures up untill Sunday.
I'm asking $265.00 shipped in the U.S.A.
 

·
Registered
Joined
·
1,530 Posts
Discussion Starter #2
Bump.
 

·
Registered
Joined
·
1,530 Posts
Discussion Starter #3
Bump again. Pics will be up on Sunday when I can get over to my storage unit.
 

·
Registered
Joined
·
1,530 Posts
Discussion Starter #4
Pictures as promised. I just noticed there are some very minor marks in the cylinder with original suzuki plating. The marks should not effect the way the rings seal to the cylinder walls. I just wouldn't feel right if I'm not completely honest about what I'm selling.







.
.
.
Price reduced to $225.00 shipped in the USA.
 
1 - 4 of 4 Posts
Top