intro/ quick question
Hey all. Long time lurker first time poster. Just have a quick question regarding the gauge cluster connector. I purchased my tl partly striped so I am unsure of what is missing. So my question is: is the connector pictured below the correct gauge cluster connector? If so I plan on installing an aftermarket gauge that does NOT have the same conector but appears to have all or most of the wires that go in to a typical cluster. Thoughts? Any problems to keep in mind?
![Material property Hand Rim Plumbing fixture]()
Here are some pics of my cafe tl.
![Vehicle Motorcycle Automotive tire Automotive exterior Car]()
![Land vehicle Vehicle Motorcycle Motor vehicle Alloy wheel]()
![Land vehicle Vehicle Motorcycle Car Automotive tire]()
![Land vehicle Vehicle Motorcycle Motor vehicle Car]()
Here are some pics of my cafe tl.
1 - 7 of 7 Posts
Thanks For the replies guys.
@Six5 unfortunately I dint go that far in to the project or else I would have painted the frame
@Six5 unfortunately I dint go that far in to the project or else I would have painted the frame
...
@Six5 unfortunately I dint go that far in to the project or else I would have painted the frame
I was just curious to see how it is structured since the subframe has minimal support.
The best picture I have is this one. I can tell you it's just two pieces of square tubing holding my ass up. Ive had no issues with it and its felt very sturdy.
![Land vehicle Vehicle Motorcycle Car Automotive tire]()
1 - 7 of 7 Posts
