TLZone Forums banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
2,323 Posts
Rifleman I hope you dont mind me adding to your list:

1)If you dont have a dremel then a flat bladed screw driver heated red hot will easily smooth out the tabs on the lower housing

2)If you undo the pinch bolts for the front brake lever/master cylinder assembly that'll give you enough cable length without having to release the cable adjusters by the throttle bodies.

3)When removing the 5mm of throttle cable guide cut two smaller sections.....much easier to snip off the cable.

And finally after buying and fitting the 'shop' version and Rifleman's version I'll buy/use Rifleman's throttle clip everytime
:) :)
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top