TLZone Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
129 Posts
Discussion Starter #1
So im going to be piecingvan engine together out of parts from 3 different engines aside from seals and bearings of course. My question is 2 fold. Should i have the case halves and crankshaft line bored and what not and have the cylinders and heads surface ground to insure a good marriage.
My next question is if so is there a good shop in or near Pennsylvania that can handlevsuch a task. I wouldnt mind have them seat the bearings and seals (where possible) at the same time as well.
 
1 - 1 of 1 Posts
Top