TLZone Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,615 Posts
Discussion Starter #1
I finally scored a full M4 system for my franken exhaust project in which I'll be using the M4 headers with GSXR1000 cans flanged on. The goal is to get the most out of my new mildly built engine and airbox. I'm certain that I'm not the only one that's had to put stock cans or bolt ons onto a full system for local sound regulations or track sound requirements. How'd you do it? I was thinking of hacking up my stock headers for it or something similar.
 

·
Registered
Joined
·
4,197 Posts
There's a post of N2wheelies in the frequent mods section with drawings of stock bolt on cans to Yosh header adapters. That's what I did for the Akra header.

Greetings
Rufer
 

·
Registered
Joined
·
2,569 Posts

·
Registered
Joined
·
2,009 Posts
measure the od of the mid pipe on the M4, memory says its bigger than the Yosh but Iam not shure, I do have faulty memory from time to time.
 
1 - 4 of 4 Posts
Top