TLZone Forums banner

Gear Shift Rod TLS - Measurement needed

2K views 5 replies 4 participants last post by  filrabey 
#1 ·
Can someone please measure the overall length of the OEM gear shift rod
Please Please Please.
Also would help if you could confirm that it is M6 (I know LH and RH Thread) and how long the threads are at either end
Please Please Please
:):):hail:hail
 
#3 ·
Not about the cost!

Thanks Steve but it's not about the bank
I actually am looking for a slightly different version but don't have the OEM one.

This is a pick of my current set up so I don't use the rod at all at the moment.
The OEM is very much a plain jane so looking for alternatives.

Thanks anyway:)
 
#4 ·
If no one else posts up by tomorrow, I'll dig mine out and give you the dimensions.
 
#6 · (Edited)
I stripped the rod from my old OEM set up: dimensions as follows

overall length of rod (rod only - not including fittings)= 200mm
length of thread (both ends) = 16mm

sod it ! just noticed you asked for confirmation of thread size :banghead give me 5...

Yep M6 it is :thumbup
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top