What wire(s) near the left head light/ front faring will shut off the bike?
Please see the attached image for exact wire connector. When I wiggle these wire I can make the dash light turn off and sometimes I have to wiggle the wire before the bike will start
Thanks for any help
Ok, I'm sick to death of the poor electrics and connections on my bike. I'm also sick of little bits being fixed and breaking because of other issues.
Suppose I wanted to build a brand new loom from scratch, with better connections and all the mods required included...
What would I need, and...
Hi everyone,
I am trying to remove the headlight, all four bolts have been removed and the headlight has been slid out. However it is still connected via the two wires going to the bulbs. There is a connector going into the headlight but I cannot seem to pull the connectors free from the...
Early in Sept. of this year I happened to be wiping my bike down when I noticed a burnt wire. So after inspecting I could see it was the regulter/rectifier wires that had toasted. No problem so I thought, Ill just order a new reg./rect. After searching I found an aftermarket one at a decent...
Just found out today, after lots of hassle wiring up my towbar lights ,that a UK 240v DIY stud/wiring sensor also detects live 12v wires. Good for sussing out live wires without cutting into the insulation. :)
Took my bike apart to polish the frame and have a two wire harness and cant figure out where it goes or if it does go anywhere. it is in the same harness of wire that run to the coil pack on the right side. it is two wires one is orange and green and the other wwire is white and black, any ideas
I'm still dealing with wiring issues.....:banghead:banghead
The guy I bought my bike from did not have a horn on it. He just said that he used the pipes to get peoples attention. I bought a used horn for it and put it on, but I can't seem to find the wires. I've searched down the colors of...
So...
As I mentioned in the last few days.......I did a soaking wet ride in the rain and ran into problems.....
So I checked the spark plus wires today....and inside part "17" on the forward facing cylinder......it was still wet inside with a little road grit too....after a day with the fan on...
Iv fitted a manual fan switch mod but when i did so i cut the wires. I am now seeing people say dont cut the wires and am a worried that i have done damage. I am having no problems and the switch works fine so can anyone please put my mind at rest.
Also, im interested in the thermostat mod but...