TLZone Forums banner

seal

  1. Is This Normal?

    Help Forum
    Still diagnosing the persistent oil leak. Since it's only a slow leak I decided to put just the clutch cylinder back together and run the bike. Figured I would catch the leak in the act and know for sure. Well... I fired him up, turned around to get my smokes out of the truck, and when I turned...
  2. water pump seal replacement

    Suzuki TL1000R & TL1000S Forum
    This past summer I sprung a leak from the weep hole on the TLS - letting me know that the seal had failed and needed replacing - I have the old seals out and am trying to install the new water pump seal :O that lives in the engine cover case on the impeller side. This seal is housed in a...
  3. is there a rubber seal inside the clutch slave cylinder

    Suzuki TL1000R & TL1000S Forum
    Not getting any pressure when squeezing clutch lever on my 98 TL1000r after bleeding it for an hour. Dont know if I have a master cylinder problem or a slave cylinder problem. I saw a picture on the forum that shows a rubber seal that goes between the slave cylinder and and the rod. Am i missing...
  4. Total Seal Gapless Rings

    Motor Tear Down and Rebuild
    Ok I just read Kendall Bergs lil write up on his 1088 and 1140 kits for the billionth time. :drool :drool In doing so I finally saw through all the pools of drool that he is using the Total Seal Gapless ring set up. I went to the company web site and read the comparo they did using a cheby...
  5. FS - TLS waterpump seal rebuild kit - $50 shipped

    Looking to Sell
    selling this since i doubt ill ever need to do this again, my motor has a brand new seal set and a new shaft :jack and only 2500 miles. selling leftover parts from rebuild time. pump cover oring, drain gasket, two (2) new mechanical seal sets, used impeller in good condition, oil seal, extra...
  6. Chain/Sprockets and Pushrod Seal

    Looking to Sell
    I took these off of my S to swap for 520. I did have to cut the master link so you will need a new one. They are 17/39 and 530 EK chain. Sprockets are in good shape and have lots of life left in them. $45 shipped to US. Clutch pushrod seal is an extra I had left over. SV1000 upgrade. $12...
  7. Clutch Push Rod Seal

    Help Forum
    How do I change this clutch push rod seal? I am able to take out the cluch master cylinder. Do i simply pluck out the push rod? Thereafter how do I dig out the seal? Will all my engine oil leak out? Do I have to drain out the engine oil to perform this change?
  8. Clutch pushrod seal help

    Help Forum
    Okay, I had oil pissing out, after ripping it all apart I find that my leak is at the clutch pushrod seal. Just had it done by recommended mechanic (I was swapping my rims, tires, and getting new chain and sprockets). I didn't have the equipment to do the rim/tire swap and I didn't feel...
  9. push rod seal fix

    Suzuki TL1000R & TL1000S Forum
    hey guys going to change all the seals on the stator side of the engine and going to use the sv1000 pushrod seal and retainer but the stealership cant find it on the parts fish. does any one have the seal and retainer number so i can just order them thanks
  10. Need to Change Front Fork Seal

    Suzuki TL1000R & TL1000S Forum
    I have a right front fork seal that I need to change. Can anyone tell me what is the best way to jack up and support the bike so I can remove the wheel and fork? Thanks!:)
  11. Nissin Caliper seal query please..

    Suzuki TL1000R & TL1000S Forum
    Does anyone know if the caliper seals on the old Gixxer four pots are tapered in the way they fit in the recess inside the calipers please? I belive the Tokico one's are but not sure about the Nissin calipers. Many thanks chaps :)
  12. Piston seal problem

    Suzuki TL1000R & TL1000S Forum
    I'm doing the front calipers and I CAN'T see the taper in the seals. The part # for the seals I have is 59300-33881 and according to Ron Ayers site there Busa seals which I think are the same. Am I just blind? No matter which way I install the seals there is a lip that sticks out towards...
  13. Oil Leak from case seal

    Help Forum
    I've got a small oil leak from the case seal on my R. it's the seal right up the middle of the motor. it drops hardly anything but sometimes smokes up when dropping on the exhaust. is there anything i can do to stop this leak without splitting the motor :puke??
  14. Is my tank seal leaking?

    Suzuki TL1000R & TL1000S Forum
    So I just got my tank and fairings back from the painters and few days ago. When he painted the tank he unbolted and took off the fuel pump and filter from under the tank. I reconnected the pump and put the tank back on the bike today. It looks like gas is seeping out of the gasket around the...
  15. New Tank - How do I seal the fuel pump?

    Suzuki TL1000R & TL1000S Forum
    I have a new tank to put on my bike. I've pulled the fuel pump out of the old tank and i'm ready to put it in the new one. What do you guys recommend sealing it with? Is there a gasket from Suzuki that I should use? It leaked on the old tank, so I want to make sure it doesn't on the new one...
  16. clutch pushrod seal

    Suzuki TL1000R & TL1000S Forum
    I bought the SV seal to replace in my TL. I went to do it today, but for the life of me can't get the allen bolt loose on the sprocket. Anybody else run into this or have any tips?
  17. Clutch Pushrod seal keeps pushing out

    Suzuki TL1000R & TL1000S Forum
    I have a 1999 tl1000r. I had a small leak coming from my clutch pushrod seal so i replaced the seal. The problem is i have been forced to replace it another 4 times. Everytime i build up a right rpm it forces the seal out. Almost like I have to much oil pressure or something. The amount of oil...
  18. pushrod seal pic...

    Suzuki TL1000R & TL1000S Forum
    The sticky in the Help section no longer has the pics for it. And a fellow TL rider gave me 2 seals for the pushrod and id like to see some pics in reference to it.
  19. Front Fork Seal Replacement.

    Suzuki TL1000R & TL1000S Forum
    So, I am a do it yourself kinda guy when it comes to my stuff. I am wondering how bad it will be to replace the front right fork seal so that it doesnt leak oil on my brakes anymore. I am currently tearing the bike apart to replace the wiring harness with one I just bought on amazon cause i...
  20. clutch cover seal

    Help Forum
    hi i have a tl1000s 97 model its covered 68000 miles engine still sweet but the clutch cover leaks its the cover off the 98 model the one with the t shaped inserts anyway i think due to lots of use the cover has shrinked because the inserts protude slighty past the plastic cover i have filled...
Top