TLZone Forums banner

metal

  1. Looking for TLR 'CUT' frame slider w/ metal sleeve insert

    Suzuki TL1000R & TL1000S Forum
    Does anyone make a TLR frame slider where you don't have to cut the fairing? :coocoo :laugh Anways, on to my real question. I'm looking for a "fairing CUT" frame slider for TLR...easy enough. But I need the type which has a metal sleeve/bushing inside the bolt hole location. This detail...
  2. Metal chips

    UK Forum (Including Scotland)
    Iv just had a look inside the second drain plug as i was changing my oil. Iv had the bike from new and never done this check before. i got just over 8000 miles on it with no running probs but just the ticking. When i pulled the plug i found some small metal bits and a chip about 2 mm size. Is...
  3. metal bits in the oil

    Help Forum
    ive finished servicing my gsxr track bike. its a 2000-2001 750. all went well except for some dirty valve covers which i ignored see the blow pic and thread here ------------->http://www.tlzone.net/forums/help-forum/107172-these-valves-dirty.html i went for a quick fang up and down the road...
  4. dremel metal cutting

    Suzuki TL1000R & TL1000S Forum
    I'm going to cut off my lower steering bearing inner race (the one that is on the bottom of the steering stem) with a dremel. Does anyone have suggestions about what attachments will work? I am not sure whether the race is steel or aluminium (or if that matters). Also, how can I be sure that I...
  5. metal screens for fairing?

    Suzuki TL1000R & TL1000S Forum
    i am doing some work on my tl and was wondering where i could get the metal screen material i have seen some bikes with covering fairing ducts. thanks.
Top