leak

My fuel tank has started leaking around the seam. There looks to have been an external repair job done with some putty by a previous owner and thats now gone porous and fuel slowly seeps through leaving a horrible orange/brown staining on the white paintwork of the tank. Anyway of doing a more...

I can smell gasoline as if the rubber seal on the gas cap is leaking...has anyone else had this problem or had to replace it? I can't find a part number for it on Ron Ayers...it looks like a complete assembly (cap, housing, etc...)

does anyone know where i can get a fuel pump gasket? i called 3 dealers and all of them say there is no gasket but i read on here that alot of people had the same leak as me it drips onto the left fairing from under the tank. thanks for any info the bikes been sitting for almost 4 months because...

All, I have an issue with my 2000 TLR leaking clutch fluid from who knows where. I fill the reservoir take a 130 mile ride to and from work and I need to refill it again. I looked for looks at the master cylinder none: I looked for leaks around the shift and nipple, none. From reading the...

Still got a leak from the left hand side, replaced generator gasgit but I think it is coming from a rubber seal that has a bar in it going to some strange round thing held on with 2 Allen key bolts. Can oil leak from hear and how easy is it to fix. And what's behind the cover next to this thing...

Hi, I have just stuck all my bike back together and I have attempted 4 ride outs now and each one I have limped home after about 12 miles. I have fixed the water leak but now I have a good oil leak. It is escaping around the clutch cover. I have stuck in a new o ring gasket but it is still...

hello.i have a 2000 tl 1000s with 4200 kms.i just notice this morning that its leaking oil on the left side.never had time to check it out yet.just wondering if anyone had this problem before

Hi all, I noticed water coming from the right hand side of my 1997 TLS. On the water pump housing there is a drain screw and just below that is a hole. It is from here the water was coming from. Looking in the manual it said that the mechanical switch and rubber washers will need to be...

ok so i laid my bike down, got cut off on the interstate by some jackass in a 6wheel coming into the fast lane with no blinker. now my rear caliper is leaking. and it seems to be leaking through the crack. only does it when pressure is put through the lines. definately coming straight down...

OK I thought I had the fuel pump seal thing figured out.... I re-bent the flange on the tank to properly meet the seal. I helicoiled the stripped out bolt holes to 10mm from 8. Locked it down and it fails an air leak test :( What a shitty setup... So my next step is to buy a non-warped tank...

hey guys i was under the tillis today and noticed oil residue on the seam between the case and the clutch cover so i wiped it off and ran the bike for a few when i shut it off it was damp there again but i almost think it was coming from the sight glass.(that was the highest point of oil...

Ok guys be nice... this is my first streetbike, but been rideing her for over two yr's.. I have two problems that I can't fig out and driven me crazy.. I just put a new battery in cause the other one died (got tired of charging it up). new battery in and samething happening it drained my new...

so after finding the tube off of my PAIR valve on my front cylinder (let me tell you, all that noise coming from that high up in the head gave me a scare) i decided not to let it happen again, and blocked the port in the head. i know that there are plates available, but who has time for...

I have slow leak and found out where its coming from. Is there a bolt in there ? If not what do you think its causing it? :)

When I lfted up my gas tank today, fuel leaked out of the vent line to the canister. Is it normal for fuel to go through this line all the way to the canister??

I'm trying to slowly build up my tool collection. I have the rear stand, allen head set, set of socket wrenches, and your basic screw drivers. What else do I need to replace seals leaking oil? What tool do I use to take off the front sprocket? What other tools will I need?

I've got a small oil leak from the case seal on my R. it's the seal right up the middle of the motor. it drops hardly anything but sometimes smokes up when dropping on the exhaust. is there anything i can do to stop this leak without splitting the motor :puke??

Hi all; I love my '02 TL1000R- plenty of power and the rumble of twin Yoshi's to keep sleepy people from drifting into my space during my daily commute. 40 miles each way, freeway early, pm along the ocean in So Cal. Oil leak- small, thought it was the clutch pushrod bearing but it doesn't look...

I did a search and found only 1 post that didn't help. Finally received used replacement pump for grandson's '01 TL1000S. Replacement pump gasket was hard & original was hard too but it was stuck to tank pretty good so I didn't change it. Needless to say, it leaked even though I used proper...

i wrecked my bike last summer and im finaly getting it back together , i put coolant in it the other day then and i came out to the garge today to do some work and i noticed fuiled on the floor , looked more into it , and when i wrecked it pushed the fan into the radiator and made a small leak ...