TLZone Forums banner

installed

  1. are these installed at the right direction?

    Suzuki TL1000R & TL1000S Forum
    water pump seals look at the bolt that hold the impeler (it's in the middle axactly ) did I put the rubber washer right (rubber side up)? thanks !! :)
  2. Headlight mod installed pics (finally)

    Bike Pictures
    It's about time I got the other projects done so I could get everything back together. I've been wanting to share these pics for a while, but just got everything back together last night. Here is the headlight from my other thread, finshed and installed!
  3. long shot - any experience with stereo installs on hondas - 03 civic

    Open Forum
    hello folks, i know its a long shot but im trying to access the antenna lead on my friends 03 civic to install a ipod interface that works via the FM receiver through the antenna lead. her car has a rear window antenna and we did a fair amount of internet research trying to figure out how to...
  4. PC3 installed, runs better, now cranks slow and won't start!

    Suzuki TL1000R & TL1000S Forum
    A couple of days ago I installed the PC3 on my TLS. It started a little harder so I was eventually going to re-map lowest RPM and TP settings to see if it would help. Well, I'm trying to get the map in it and I don't have a 9v battery to load it so I have to do it while it's running. I'm out...
  5. Installed TRE, everything right?

    Suzuki TL1000R & TL1000S Forum
    I just installed my TRE today it's a JSD3A from JSD Products. Install went fine, after initial start and warm up my bike now idles slightly higher at about 1.5k rpms instead of a slightly steadier 1.25k rpms. Seems a little bouncy now kinda ticking back and forth over the 1.5k. I'm assuming...
  6. Leo Vince X3 Installed on the Husqvarna SM610

    MotardZone
    Hi all, got finished modding the Husky tonight, with my fellow squid squad member Tye. Added the Leo Vince X3 pipe and I modded the O2 sensor. I used the TL diagnostic switch I have had for many years, as it is the same connector as the O2 sensor. Added a 2.2 kohm resistor to fool the ECU...
  7. valve spring installed height?

    Suzuki TL1000R & TL1000S Forum
    ANybody know the installed height of the valve springs (and exactly how that was measured)?
Top