TLZone Forums banner

crankcase

  1. Gasket and bearing set for a crankcase rebuild?

    Suzuki TL1000R & TL1000S Forum
    Sending her in for a crankcase replacement after being a little, well, retarded in my application of mechanical repair. I was a touch over zealous when hammering a Recoil expansion thread into the oil drain and smashed the interior of the case. Missing insert, shrapnel all up inside her...
  2. Crankcase over pressurised (positive pressure I think it's called)

    Help Forum
    Hi all, Hope you can throw your two cents in. I did start this thread about this problem: http://www.tlzone.net/forums/help-forum/129222-oil-leak-left-side-near-clutch-pin-litres-dumped-seconds-slow-speed-2min-warm-up.html But I thought I'd start a new thread about it because it's no longer...
  3. Oil Crankcase Leaking 1997 TL1000S

    Help Forum
    This thing was sweating oil out, so I replacethe gasket/o-ring and used some sealer. Took it for a spin, leaking still, torqued the nuts some. Now it leaks even worse. It seems it's not fitting correctly, as there is overhang from the plastic case and where it is supposed to be flush on the...
  4. Oil Crankcase Leaking 1997 TL1000S

    Help Forum
    This thing was sweating oil out, so I replacethe gasket/o-ring and used some sealer. Now it leaks even worse. So I figure: 1. The ring is improperly installed 2. The cover (plastic) is warped
  5. Crankcase breather hose Kink. boom

    Suzuki TL1000R & TL1000S Forum
    I have been going over the tls this winter and tried starting the thing with the crankcase breather hose kinked. it idled like shizz and then backfired a couple of times. I turnd it off now its running on one cylinder. Maybe the cam timming some how???
  6. clutch basket and crankcase help need

    Performance Enhancement
    i wrecked my tl being stupid and wheeling something that just has alot of power. anyways when the bike landed it hit the oil fill case and cracked that open and broke some teeth of the clutch basket. i have orderd a new baskest . my question is do i need to remaove the crank case to take the...
Top